Service & Operation Manuals

The set of documents contains of two papers providing the operator's guide for the RadaScan 1.0a and 1.0b. The layout of both papers is similar - starting with the introduction to the system components and basic operating principles, software versions and serial nos.

Then the two main chapters come providing the instruction on the use of the RadaScan including the starting up, status bar, navigation, configuration, display options, feed format, communications, log files etc., together with the service access mode. The closing chapter of the paper contains all necessary specification information.

MAN B&W DIESEL - K90MC-C6-TII Project Guide - Camshaft Controlled Two Stroke Engines.

Here is the instruction plus  operational manual released by Fuji Electric for their X Model microcontrollers. It includes chapters that are covering the installation of the microcontrollers, notes on wiring and proper usage, specification and troubleshooting.

The installation chapter provides all necessary guidance and maintenance precautions to be taken into account, together with the caution on installation of the microcontrollers and precautions in wiring connection plus the requirements for the key operation and operation in case of abnormalities. Model configuration, dimensions, parts and all other important information have also been covered.

Complete package of documents for the MAXI 50SL-1 waste oil incinerator. It includes final drawings for the above noted equipment, general specification, technical data for the incinerator and its components, loose parts for waste oil tank, and spare parts, list of valves and list of control, safety and automation.

The publication also provides readers with the process diagram for the incinerator, properties of the exhaust gas, piping diagrams, drawings of the expansion joints, main and alarm current, primary temperature control, alarm circuit, alarm and motor control, incinerator control and primary burner control, sludge alarm circuit and pilot lamps, external alarm and wealth of other technical information, data and drawings.

Here is the full official set of service letters for 2012. All in pdf with excellent quality. The documents contained in this technical archive are expected and have already proven to be of great practical use for ship engineers. Thirty-one letter sharing experience on the issues such as below: distance sleeves for connecting rod tightening, piston rings, inspection of nozzle holder sealing surface, air starter re-arrangement, safety spare parts for different models of Wartsila 20 engines, plus cylinder liner maintenance, sulphur-dependent cylinder oil feed rate, piston assembly, piston skirt, piston ring tensioning device, and more...

Official service bulletin released by Wartsila and containing necessary technical information to all operators and owners of the RTA/RT-FLEX diesel engines. The content is presented in thee parts. The first one is introductory while the other two parts are dedicated to the considerations and recommendations.

Subject engines have been optimized to operate in the range of loads above approximately sixty percent CMCR. Continuous running of the engine at lower loads is still possible; however, this will influence the engine components and its operational parameters. This manual gives the guidelines for the low-load operation...

One more official service bulletin by Wartsila, this one dedicated to he use of the distillate fuel. The company allows for the engine produces to be operated on all fuel oils supplied under the ISO 8217 spec. The existing and foreseen legislation addressing marine fuels is actually limited to prescribing the max content of sulphur or to reducing the sulphur content in the exhaust gases with alternative methods of equal effectiveness.

The present document deals with the minimum viscosity of marine fuel, use of distillate fuels, selection of the cylinder oil, change-over procedure, arrangement of the fuel oil system, ISO 8217 fuel standard. Official release by Wartsila Switzerland applying to both RTA and RT-Flex engines.

This service bulletin was specifically released to provide owners and operators of the engines in question with necessary information on the updated procedure of running-in to be followed for the new piston rings straight after the piston overhaul/replacement of liners on the diesel engines being in active service.

The practical guidelines contained herein are mainly based on the professional experience of the Wartsila specialists with specifications for the cylinder liners/piston rings. The run-in is required after the new cylinder has been fitted and even when only piston rings have been subjected to replacement, the main purpose of doing this is to achieve best and fast rings sealing...